ELF Match Pro Trigger with ELF PRO-LOCK
Threaded Mounting System
Our match trigger got a makeover by adding an incremental adjustment knob. The advantage to this knob is to adjust the pull weight by increments by turning it with your finger or any flat tool/coin. The spring in the housings and the notch on the adjustment screw does not allow the trigger tension to change its settings without manually setting it and will not allow it to back out. If it did back out, the trigger will still function just under 3lbs. It is still our normal match trigger as before but even more bulletproof!
The ELF Drop-In Match Pro Trigger
has been built for performance. The Elf Match Pro Trigger is identical to
the Match Trigger with the addition of a proprietary threaded mounting
system. The combination of aerospace grade sealed bearings,
precision ground threaded bushings, and screws instead of traditional pins
provide a rock-solid trigger system. Since their inception, AR
platforms have always used pins to mount the trigger and hammer in the lower
receiver. Because pins require some "play" in order to be
installed, there is always a little play in the trigger system. This new
threaded system adds a level of "solid" you need to feel to
understand the difference. Pull weight is so easy to adjust it can be done
in seconds without removing the trigger from your lower receiver. A
second-to-none AR- 15 drop-in trigger system that is strong and light, made of
wire EDM machined, hardened A2 tool steel and lightweight aircraft-grade
aluminum. Installation can be done in minutes using the supplied installation
screws. The Match Pro trigger may be ordered with a curved or straight shoe.
The amazingly short takeup,
glass-rod crisp break and next to zero over-travel can be compared to the
finest custom 1911 triggers. Adjustability puts you in charge based on your
current use. If you are looking for the finest adjustable trigger for your
AR-15 platform, this is the trigger system for you.
Will work in a B&T, but please write in the comments to remove the adjustment knob to an allen key screw in order to fit!
Features
- Proprietary Threaded mounting
system for rock solid installation.
- Incremental Adjustable Knob
- Compatible with ALL calibers -
5.56, 9mm, .308 etc.
- Fits any mil-spec AR-15 (Standard pin size, no large pin Colt)
- Absolutely Drop-Safe regardless of pull-weight
- Factory set Pull-weight is approximately 50% lighter
than that of a standard AR-15 trigger, providing a great combination of
speed and accuracy
- Adjustable from 4lbs to 2 3/4lbs without removing from
lower
- Full power proprietary Double-Double torsion hammer spring ensures proper ignition of
primer
- Very short pull and reset allows for rapid follow up
shots and greater accuracy
- Sturdy trigger assembly designed for rugged,
trouble-free use; Made of lightweight aircraft-grade aluminum and hardened steel
- Unique design of disconnect allows full 1/4” width
eliminating possibility of wear and double-firing
- High performance trigger and hammer needle bearings for
smoother and faster firing
- Benefits a wide variety of AR-15 enthusiasts, including
collectors, competitive shooters, hunters, military, law enforcement, and
disabled veterans
- 100% made in America with a Lifetime Guarantee!
