ELF AR-10 Trigger
Our match trigger got a makeover by adding an incremental adjustment knob. The advantage to this knob is to adjust the pull weight by increments by turning it with your finger or any flat tool/coin. The spring in the housings and the notch on the adjustment screw does not allow the trigger tension to change its settings without manually setting it and will not allow it to back out. If it did back out, the trigger will still function just under 3lbs. It is still our normal match trigger as before but even more bulletproof!
The ELF Drop-In AR-10 Trigger has been built to withstand the punishment of
high powered calibers. The only AR-10 trigger using aerospace grade sealed
bearings, making for an incredibly smooth and fast trigger pull. Our exclusive
.043 double double wound polished piano wire hammer spring ensures full
ignition of any ammo including .308 and 7.62x39. Pull weight from 2 3/4lbs to
4lbs is so easy to adjust it can be done in seconds without removing the
trigger from your lower receiver. The AR-10 trigger is essentially the service
trigger with a lighter pull weight range.
A second-to-none AR-10 drop-in trigger system that is strong and light, made
of wire EDM machined, hardened A2 tool steel and lightweight aircraft-grade
aluminum. Installation can be done in minutes using your AR’s original
hammer and trigger pins. The AR-10 trigger may be ordered with a curved or
straight shoe.
The amazingly short take-up, glass-rod crisp break and next to zero overtravel
can be compared to the finest custom 1911 triggers. Adjustability puts
you in charge based on your preference. If you are looking for the finest
adjustable trigger for your AR-10 platform, this is the trigger system for you!
Features:
- Fits any mil-spec AR-10 (Large pin Colt available)
- Incremental Adjustable Knob
- Absolutely Drop-Safe regardless of pull-weight
- Adjustable from 2 3/4lbs to 4lbs without removing from lower
- Proprietary double-double torsion hammer spring ensures proper ignition of
any ammunition
- Very short pull and reset allows for rapid follow up shots and greater accuracy
- Sturdy trigger assembly designed for rugged, trouble-free use; Made of lightweight
aircraft-grade aluminum and hardened steel
- Unique design of disconnect allows full 1/4” width eliminating possibility of wear and double-firing
- High performance trigger and hammer needle bearings for smoother and faster firing
- 100% made in America with a Lifetime Guarantee!
